Osmo Farbe

Stone and Terracotta Oil

colours

Ideal for protecting microporous stone and terracotta surfaces

Clear, satin natural oil impregnation penetrates in the microporous surface and will not form a film on the surface. Through the impregnation with Osmo Stone and Terracotta Oil, the microporous surface becomes water and dirt repellent as well as stain-resistant. Dust resulting from screed and concrete surfaces is greatly reduced.

Osmo Stone and Terracotta Oil is suitable for the clear impregnation of microporous natural stone with a polished, sanded or break surface and artificial stone in outdoor areas. Especially suited for paving and windowsills made of granite as well as limestone and slate.

32 m²/1 lBased on renewable raw materialsMircoporous and breathable surfaceWater and dirt repellent surfaceEasy to clean and maintainRecoatable after approx. 8-10 hoursEnhances the colour of the substrate
Oil advantages – Simple application, Water beading effect, No flaking or peelingSafe for humans, animals and plants (when dry) - Suitable for children's toys - According to DIN EN 71.3; fast to perspiration and saliva

Storage

5 years and longer if stored in the originally closed can. If thickened by frost, store at room temperature for 24 hours prior to use.

COLOUR CODECAN SIZE LITREARTICLE NUMBER

620 Clear

Satin

0.7511500112
2.5011500113

NUMBER OF COATS
Two coats on an untreated substrate; for renovations, normally one coat on the clean surface is sufficient.

TOOLS
Flat BrushMicrofibre RollerFlooring/Decking brushClothPad


Impregnation results vary greatly depending on the substrate and the surface condition. Therefore a trial application is always required. Product coverage varies greatly depending on the absorption properties of the substrate. Very dense and polished stone absorbs only maximum half of the stated amount of oil, whereas absorbent concrete or break surface stone absorbs up to double the amount of oil.

Cleaning of tools:
With Osmo Brush Cleaner (free of aromatic compounds).

Drying time:
Approx. 8-10 hours (normal climatic conditions, 20-23°C/ 50-65% rel. humidity). Ventilate well while drying. Lower temperatures and/or higher air humidity may increase drying times significantly. After 2-3 weeks, the surface is fully cured.

Caution:
Keep out of reach of children. Safety data sheet available on request.

Disposal:
Dispose of product residuals according to the official guidelines (European Waste Code (EWC)-Code 08 01 12). Only completely emptied cans can be recycled.

Verbrauchsrechner

HOW MUCH COATING DO I NEED?

With our finish calculator, the right amount of coating necessary for your project can be calculated quickly and easily.
Please follow our advice in the product information sheets for the correct application.

To the finish calculator