Removes old Decking-Oil and wood stains evenly and efficiently
Ready-to-use, viscous paint remover especially developed for removing old existing oil surface finishes in outdoor areas. Afterwards the surface can be degreyed/neutralized with Osmo Wood Reviver Power-Gel and then re-oiled.
Osmo Paint Remover Gel removes old Decking-Oil and wood stains on timber decking and garden furniture made of wood. Ideal for removing oil-based surface finishes on partially weathered timber decking so that an overall oil-free wood surface is achieved.




Ingredients
Osmo Paint Remover Gel contains non-ionic surfactants (< 5 %), lye. Solvent: water.
Storage
2 years or longer if stored in the originally closed container. Do not expose to frost or temperatures above 30 °C!
COLOUR CODE | CAN SIZE LITRE | ARTICLE NUMBER | |
---|---|---|---|
| 0.50 | 13900142 | |
2.50 | 13900143 | ||
5.00 | 13900144 | ||
10.00 | 13900145 |
With a brush or Osmo Decking Cleaning Brush, apply product thick enough (approx. 200 ml/m²) on the dry surface to be cleaned, and allow the gel to react for 60 minutes (but not longer than needed!). Keep surface damp during reaction time (e.g. with a spray bottle). Afterwards scrub the surface with a lot of clear water along the wood grain. After drying, inspect the wood surface and repeat the process if necessary. Residues from Paint Remover Gel may have a negative influence on the drying and adhesive properties of subsequent coatings. Therefore, it is absolutely essential to thoroughly rinse the surface after treatment. If the wood surface should be re-oiled, the surface must be neutralized and de-greyed with Osmo Wood Reviver Power-Gel after drying.
With soap and water.
Before applying a new coating, allow the wood to dry thoroughly (approx. 24-48 hours). Lower temperatures and/or higher air humidity may increase drying times.
Cover all areas that should not be treated, such as sensitive plants, porous substrates (e.g. light-coloured pebble dashed concrete, render etc.), aluminium, zinc or lacquered surfaces. Have mop water ready to rinse any surfaces (e.g. aluminium, zinc or lacquered areas) that have accidentally come into contact with the gel. Please wear safety gloves and goggles.
May be corrosive to metals.
Causes skin irritation.
Causes serious eye irritation.
If medical advice is needed, have product container or label at hand.
Keep out of reach of children.
Keep only in original packaging.
Wear protective gloves/eye protection.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
Take off contaminated clothing and wash it before reuse.
Reacts with acids with evolution of heat. Risk of splashing!
Caution! Do not use with other products.
Contains
DECYL GLUCOSIDE <5 %.
Dispose of product residuals according to the official guidelines (European Waste Code (EWC)-Code 08 01 21*). Only completely emptied cans can be recycled.

HOW MUCH COATING DO I NEED?
With our finish calculator, the right amount of coating necessary for your project can be calculated quickly and easily.
Please follow our advice in the product information sheets for the correct application.